Introduction to the Hongxing Sand Making Machine

Sand making machine is the same with other equipment, we should care the maintenance and regularly check of this machine. During the work and research of the sand making machine, Hongxing expert has summarized several rust methods: abrasive rust, high pressure water abrasive rust, chemical rust, and small pneumatic or electric rust and so on. Abrasive rust of the sand making machine mainly depends on the impact force of the particulate matter to realize the clean of the machine. High pressure water abrasive rust uses the high pressure of the water to clean the surface of the machine. This method will not harm the crushing machine and no dust pollution. To the sand making machine, this method will cause the rusting phenomenon.

In the housing construction, road construction and water conservancy construction and other industries, the sand and gravel has been the concerned issues of user. With the large number use of the natural sand, it cannot meet the requirement of economic develop. The customer has the higher requirement on the quality of the artificial sand. Then the sand making machine is responds to the social demand. The operation process of the sand making machine is divided into primary crushing, secondary crushing and the fine crushing.

The new sand making machine adopts the new type of crushing chamber and is equipped with the counterweight wheel. The crushing efficiency and the production ability are higher than the traditional crushing machine. The sand making machine responds to the social call of the green development. It is featured with lower energy consumption, low noisy, low vibration and no dust pollution. This machine pushes the quick develop of the mining industry. The sand making machine has attracted great attention in the mining market because of its good quality and the advanced technology.